Copying From The Bypass Tray - Ricoh Aficio 2035e Operating Instructions Manual

Copying

Copying from the Bypass Tray

Use the bypass tray to copy onto OHP
transparencies, adhesive labels, translu-
cent paper, postcards and copy paper
that cannot be loaded in the paper trays.
2
Preparation
When the duplex unit is attached,
the default is [1 Sided→ → → → 2 Sided].
When copying from the bypass
tray, select [1 Sided] for copying in
[Dup./Combine/Series] (for example
[1 Sided→ → → → 1 Sided] or [2 Sided→ → → → 1 Sid-
ed] ). You can change the initial set-
tings. See p.92 "Duplex Mode
Priority" .
Important
❒ When paper larger than 433 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
Note
❒ If you do not use the standard size
copy paper or if you use special pa-
per, you should input vertical and
horizontal dimensions. See p.14
"Placing custom size originals".
The sizes that you can input are as
follows:
Metric
version
Inch
version
*1
The range is 148–432 mm (5.8"–17")
when the booklet finisher is in-
stalled.
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper:
Metric
version
Inch
version
18
• Vertical: 100–297 mm
• Horizontal: 148–600 mm
• Vertical: 3.9"–11.6"
• Horizontal: 5.8"–23.4"
A3L, A4KL, A5KL, 8
× 13"L
A3L, 11" × 17"L, 8 " ×
1
/
2
" × 8
1 1
11"KL, 5 / / "L
2 2
❒ When copying on OHP transpar-
encies or paper heavier than 128
2
g/m (about 34 lb.), you need to
specify the paper type. See p.20
"When copying onto special pa-
per" .
❒ The maximum number of sheets
you can load at the same time de-
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
A A A A
Open the bypass tray.
B B B B
Insert the paper with the side you
want to copy facing down until
you hear the beep, and then align
the paper guide to the paper size.
*1
*1
1.
Extender
1
/ "
2
ZDSH110J
ZDSH100J