Karaoke - Aiwa Z-R900 Operating Instructions Manual

6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Total number of Remaining time Programmed
programmed tracks of side A track numbers
7 Press the EDIT/CHECK button to select side B
and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
8 Press the @/OREC/REC MUTE button and then
press the <> button within 2 seconds to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side A ends, recording
on the back side B starts.
To stop recording
Press the ll button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button to select side
Aor B, and press the <4 or BP button repeatedly.
Track Program Programmed
Disc number number number track numbers
To change the program of each side
Press the EDIT/CHECK button to select side A or B, and press
the HICLEAR button to clear the program of the selected side.
Then program tracks again.
To clear the edit program
Press the EICLEAR button twice so that "EDIT" disappears on
the display.
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
KARAOKE
MICROPHONE MIXING
VOCAL FADER/
MULTIPLEX
Two microphones (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
Use microphones with standard plugs (#6.3 mm, */4 inch).
Before connecting a microphone
Press the MIC button and turn the VOLUME control
counterclockwise until "MIC OFF" is displayed.
7 Connect your microphones to the MIC 1 and MIC
2 jacks.
MIC 1
En
2 Press one of the function buttons to select the
source to be mixed, and play the source.
3 Adjust the volume and tone of the source.
4 Press the MIC button and turn the VOLUME
control within 4 seconds to adjust the
microphone volume.
The microphone volume can be selected from 1 to MAX (7)
or OFF (cancel).
The volume of both microphones is adjusted simultaneously.
5 Press the ECHO button and turn the VOLUME
control within 4 seconds to adjust the echo level.
The echo level can be selected from 1 to MAX (7) or OFF
(cancel).
To change the delay time of echo
Hold down the ECHO button while the echo is on. "ECHO-L"
(Long) and "ECHO-M" (Medium) are displayed alternately. At the
desired position, release the button.
To record microphone sound mixed with source sound
Follow the procedure for recording from the sound source (see
page 16). .
The SYNC DUB button cannot be used for mixing recording.
When not using the microphones -
Set the microphone volume and echo level to OFF and remove
the microphones from the MIC jacks.
ENGLISH 20