Table of Contents
Advertisement
PLAY WITH DOLBY PRO LOGIC
DOLBY PRO
LOGIC
1 Start playback of the video source.
2 Press the DOLBY PRO LOGIC button.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press the DOLBY PRO LOGIC button repeatedly until P-oFF is
displayed.
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes.
PHANTOM
mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 CH LOGIC mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 CH LOGIC
Press the DOLBY PRO LOGIC button to run through the mode
choices for selection in the following sequence.
ie NORMAL—> PHANTOM —> 3 CH LOGIC 1]
cancel
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 on page 17.
[NOTE
¢ Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
* The full DOLBY PRO LOGIC effect cannot be obtained when
using software without DX) [paxvsumouno] mark. In this case, use
the DSP SURROUND system instead.
(See page 7.)
KARAOKE
MICROPHONE MIXING
MULTIPLEX
Two microphones (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
Use microphones with standard plugs (26.3 mm).
Before connecting a microphone
Set the MIC MIXING control to MIN.
1 Connect your microphones to the MIC 1 and MIC
2 jacks.
MIC1
MIC2
3) ©
2 Press one of the function buttons to select the
source to be mixed, and play the source.
3 Adjust the volume and tone of the source.
4 Adjust the microphone volume with the MIC
MIXING control.
The volume of both microphones is adjusted simultaneously.
To echo the microphone sound
Press the MANUAL SELECT button on the remote control once
and then press the <<
or ®®
button.
The display changes
as follows.
MAX (maximum) © -3 © -6 .... -15 © MIN (minimum)
¢ Make sure the SURROUND and the DOLBY PRO LOGIC are
turned off before pressing the MANUAL SELECT button.
To record microphone sound mixed with source sound
Follow the procedure for recording from the sound source (see
page 13).
The SYNC DUB button cannot be used for mixing recording.
When not using the microphones
Set the MIC
MIXING
controls
to MIN
and
remove
the
microphones from the MIC jacks.
ENGLISH 18
Advertisement
Table of Contents
