Yamato VE2700-8 class Instruction Manual page 24

5. Proper operation
With UT, UT-A device
When not threaded, thread correctly as shown in Fig. 5-5.
When had been threaded, knot the preset thread and new
one together to rethread.
A, B, C: Needle thread
Pull out the threads until they come to the front of the
needles. Then, cut off the knots before passing them
through the needle eyes.
Thread the needles correctly so that the left needle
thread A is at the inmost position as shown in the fig-
ure.
D: Top cover thread
Pull the thread until the knot comes out.
Then, cut off the knot.
E: Looper thread
Pull the thread until the knot comes out.
Then, cut off the knot.
For stretchable thread
Fig. 5-5
VE2700-8
For stretchable thread
with UT, UT-A device
Fig. 5-6
②
Install the top cover
thread eyelet ② and
pass thread through
it ②.
☆ stretchable
When using
thread
with the ST2-A device.
14
D E
C
A B
☆ For stretchable thread