Table of Contents
Advertisement
4. OPERATION AND SERVICE
Operation and service
Maintenance and safety notice
Vitus Audio products are designed to run for many years without
the need for regular maintenance.
The Vitus Audio RD-101 contains no user serviceable parts except
from the mains fuse. Do not attempt to open the case as there are
potentially dangerous voltages present inside. Should your RD-101
show signs of malfunction, then please contact your dealer
or Vitus Audio.
22 | RD-101 Owner's manual
Mains supply voltage
Any unit may be set for operation in 100V, 115V or 230V/240V AC.
The units shipped are set for the mains supply voltage of the
destination. The mains supply voltage can be changed in the product.
In some cases, this work can be performed by our authorised partners
around the world. In rare cases we would ask that the product is
returned to the Vitus Audio factory in Denmark for the conversion
to be done.
Operation and service
Mains fuse
The mains fuse is accessible from the outside of the amplifier. You
will find the mains fuse, just below the power inlet. If the fuse blows,
you can easily replace it. The fuse only blows on the occurrence of
power surges or if there is a fault in the unit. Normally power surges
cause no other damage other than blowing the fuse. When the fuse
blows repeatedly on replacement, then the unit most likely has a
malfunction. In case of malfunction the unit must be returned to
Vitus Audio for repair.
4. OPERATION AND SERVICE
Fuse type:
Physical size - 20 x 5mm
240V - 6.3A T (Time lag fuse)
230V - 6.3A T (Time lag fuse)
115V - 12A T (Time lag fuse)
100V - 12A T (Time lag fuse)
Replacing the fuse with a fuse of a type and rating different from
the original, might result in damage to the unit and injury to you
(the user). Damage to the unit as a result of incorrectly replacing
the mains fuse, will invalidate the warranty.
For an explanation of how to replace the fuse see chapter 4
"replacing a blown fuse".
RD-101 Owner's manual | 23
Advertisement
Table of Contents
