Table of Contents
Advertisement
Chapter 2
Configuration and Installation
Caution
an antistatic bag. Open only at an approved workstation and observe precautions for
handling electrostatic-sensitive devices.
Note
When adding or removing a motion controller, you must be logged on with
administrator-level access. After you have restarted the system, you may need to
refresh Measurement & Automation Explorer (MAX) to view the new controller.
PXI Motion Controllers
1.
Power off and unplug the chassis.
Caution
computer must remain unplugged until the installation is complete.
2.
Choose an unused peripheral slot and remove the filler panel.
3.
Touch a metal part on the chassis to discharge any static electricity.
4.
Insert the NI 7340 motion controller into the PXI slot as shown in Figure 2-1. Use the
injector/ejector handle to fully secure the device into place.
Figure 2-1. Installing an NI 73xx Motion Controller in a PXI Chassis
1
PXI Chassis
2
PXI System Controller
3
NI 73xx Motion Controller
5.
Attach the front panel of the NI 73xx motion controller to the front panel mounting rails of
the chassis with the slot screws on the chassis.
Caution
power on the motion system. Safety devices include inhibits, limit switches, and
emergency shut down circuits.
2-4 | ni.com
The NI 7340 motion controller is a sensitive electronic device shipped in
To protect yourself and the computer from electrical hazards, the
2
3
Make sure you have correctly connected all safety devices before you
1
P X
I - 1
0 0 0
B
5
4
4
Front-Panel Mounting Screws
5
Module Guides
6
Power Switch
6
Advertisement
Table of Contents
