Table of Contents
Advertisement
TouchPad
Description
TouchPad for use in models without an NFC module
TouchPad for use in models with an NFC module
Before removing the TouchPad, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the TouchPad:
1.
Disconnect the card reader cable from the ZIF connector on the TouchPad (1).
2.
Disconnect the TouchPad button board cable from the ZIF connector on the TouchPad (2).
3.
Disconnect the NFC module cable from the ZIF connector on the NFC module (3).
4.
Remove the four Phillips M2.0x2.0 screws (4) that secure the TouchPad to the computer.
5.
Remove the TouchPad from the computer (5).
Reverse this procedure to install the TouchPad.
Bottom cover on page
Battery on page
40).
38).
Component replacement procedures
Spare part number
L13685-001
L15394-001
61
Advertisement
Table of Contents
