Changing To The Laptop Mode; Using The Usb Floppy Disk Drive (Optional); Connecting The Usb Floppy Disk Drive - Toshiba Tecra M4-103 User Manual

You can set the orientation of the desktop screen just after rotating the
display from [Start]-[All Programs]-[TOSHIBA]-[Tablet PC]-[TOSHIBA
Rotation Utility]

Changing to the laptop mode

To change the Tablet mode to the laptop mode, follow the instructions
below.
1. Press the Display latch and raise the display to the upright position
carefully.
2. Rotate the display counter-clockwise slowly.
3. Turn the display latch toward you for the next closing of the display.

Using the USB floppy disk drive (optional)

An optional USB floppy disk drive connects to one of the computer's USB
ports. It accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer
to Chapter 2,

Connecting the USB floppy disk drive

To connect the drive, plug the floppy disk drive's USB connector into a
computer's USB port.
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection, doing so can damage the
connecting pins.
If you connect the USB floppy disk drive after turning on the computer, it
will take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
TECRA M4
The Grand Tour, for more information.
USB connector
Connecting the optional USB floppy disk drive
Operating Basics
USB port
4-13