Table of Contents
Advertisement
Hold the door glass panels by their top edge
and carefully pull them out one by one. Start
from the top panel. Make sure the glass slides
out of the supports completely.
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A and
B) back in the correct sequence. The middle
panel (B) has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame (B) on the
screen-printing zones is not rough when you
touch it.
A
B
Troubleshooting
WARNING!
Refer to Safety chapters.
www.zanussi.com
Make sure that you install the middle panel of
glass in the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
A
B
21
Advertisement
Table of Contents
