Table of Contents
Advertisement
2
Unpack all the parts
Control Box HSA6092
Unpack the kit content on a table. Remove the
mounting plate (if fitted) from the control unit by
sliding plate downwards. A power adaptor is
supplied that plugs into the main wall socket and
control unit. Plug in the power adaptor and connect
the box to your internet router using the cable
provide.
Battery
<On Off>
Battery switch
• In addition to the adapter, there is a rechargeable
battery inside the control unit that serves as a
backup in case of a power failure. A fully charged
battery can provide backup power for a period of
at least 10 hours. It takes approximately 72 hours
to fully charge the battery.
• Remove the rubber battery switch cover and
locate the battery switch. Switch ON the internal
battery and replace the rubber cover.
Top LED 1 (Panel Status)
Red
ON: System Arm
FLASH: Home Arm
Green ON: Disarm
FLASH: Learn mode
OFF: Walk test mode
Middle LED 2 (Alarm & Fault Status)
Red
ON: Alarm been triggered
FLASH: Ongoing alarm event
Yellow ON: Device fault (Tamper/Low battery)
FLASH: Mains power failed
OFF: Normal
Bottom LED 3 (Operation Status)
Yellow ON: Network problem.
FLASH: Disconnected from Yale server
Green ON: Normal
4
Power
Learn
Power socket
Learn button
Network Port
(press and hold
(connect to Broadband
for 3 secs)
Internet router)
Siren HSA6050
WARNING
The siren is very loud, be prepared! Take care not to
activate the siren tamper switch unnecessarily.
1 Remove the cover by unscrewing the single screw
located on the lid. Power switch to ON position.
PIR Movement Detectors HSA6020
1 Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
Y
Status
LED
Learn/Test
Button
Door/Window Contacts HSA6010
1 Pull out the battery saver tab on the side to activate
the battery.
LED
Sensor
Magnet
ale
Cover
screw
Learn/Test
button
Gap no more
than 10mm
Advertisement
Table of Contents
