Beverage-Air CF3HC Series Installation And Operation Manual page 8

MAINTENANCE GUIDELINES CONT'D
2. Unplug the unit until all the frost is gone.
3. When the ice has melted wipe up any water left on the freezer floor.
4. Allow the freezer to refrigerate and cycle before placing the product back into the freezer
To defrost while keeping the freezer plugged in place a clean dry soft cloth over the product to catch
the frost that will be removed. Remove the frost using a plastic scrapper trying to eliminate as much
frost as possible.
CLEANING THE UNIT INTERIOR
WARNING! DAMP OBJECTS STICK TO COLD METAL SURFACES.
DO NOT TOUCH THE INTERIOR METAL SURFACES WITH WET OR DAMP HANDS.
After defrosting, wash the inside surfaces of the freezer with a solution of two tablespoons of baking
soda in one quarter of a gallon (1.1 liters) warm water. Rinse and dry. Wring excess water out of the
sponge or cloth when cleaning in the area of the controls, or any electrical parts. Wash the removable
parts and door with the baking soda solution, or mild detergent and warm water. Rinse and dry. Never
use metallic scouring pads, brushes, abrasive cleaners, or alkaline solutions on any surface. Do not
wash removable parts in a dishwasher. Do not shower water with a hose nor use ammonia based
cleaners.
WARNING! WARNING THE LOWER SIDE OF THE GLASS LIDS IS PROVIDED WITH A SPECIAL
FILM. DO NOT USE RAZOR BLADES OR OTHER SHARP INSTRUMENTS WHICH CAN SCRATCH
THIS SURFACE AND DAMAGE THE FILM.
https://beverage-air.com/ | 8