Operation - Sharp UA-KIN40E-W Operation Manual

OPERATION

START/STOP
START
♪
NOTE
• When the product starts operation, the
operation starts in the previous mode it was
operated in.
HUMIDIFICATION
SETTING
ON
♪
NOTE
• When operating with Humidification ON in
the modes in the table below, the product
automatically controls humidity by sensing
temperature and humidity. (Except MAX / MED
/ LOW mode.)
Temperature
(T)
ALL MODE*
T 18 ºC
18 ºC T 24 ºC
24 ºC T 28 ºC
28 ºC T
* Except MAX / MED / LOW / SLEEP
STOP
♪
～
OFF
♪ ♪
Humidity
SLEEP
MODE
65 % 65 %
60 % 65 %
55 % 60 %
45 % 50 %
AUTO MODE
The fan speed is automatically controlled depending
on the six detection. (PM2.5 / Usual dust / Odour /
Temperature / Humidity / Light)
SELECT AIR VOLUME
AND MODE
POLLEN:
The Sensitive Dust Sensor sensitivity is
automatically increased and quickly detects
impurities such as dust and pollen and clean the air
powerfully.
SLEEP:
The product will operate quietly, and the fan speed
is automatically switched depending on the amount
of impurities in the air.
When the Light Control is set to "Auto", Display and
Cleanliness Indicator automatically go off. (Page
12)
EN-10
♪
♪ ♪
POLLEN
♪
SLEEP
♪
LOW
♪
MED
♪
MAX