SPECIFICATIONS ..........10 Keep proof of purchase because it is necessary to apply warranty rights. Thank you for purchasing this SHARP Air Purifi er. Please read this manual carefully before using the product. This manual should be kept in a safe place for...
Failure to do so can cause a short circuit resulting in electrical shock or fire. • If the power cord is damaged, it must be replaced by the manufacturer, its service agent, a Sharp authorized Service Centre or similarly qualified persons in order to avoid a hazard.
Page 4
MAINTENANCE • Be cautious when cleaning the product. Strong corrosive cleansers can damage the exterior. CAUTION OPERATION • Do not block the Air Inlet or Air Outlet. • Always operate the product in an upright position. • When moving the product, use the handle on the back of the product. •...
Page 5
INSTALLATION • Avoid locations where furniture, fabrics, or other objects can come in contact with the product and interfere with the intake and outtake of air. • Avoid locations where the product is exposed to condensation or drastic changes in temperature. Appropriate room temperature is between 0 – 35 ºC. •...
OPERATION PRINCIPLE Please read before operating your new Air Purifier The air purifi er draws in room air through the Air Inlet, circulates it through a Pre-Filter and a HEPA Filter inside the product, and then discharges it through the Air Outlet.
PART NAMES FRONT BACK Main Unit HEPA Filter Air Outlet Back Panel (Pre-Filter) Fan Speed Lamps (Green) Air Inlet Fan Speed MODE Button Handle REPLACE FILTER Button, Lamp (Orange) Power Cord Power ON/OFF Button Power Plug Quick Clean Button, Lamp (Green) EN-5...
BEFORE FIRST USE Always be sure to remove the power plug from the wall outlet. • To maintain the quality of the fi lter, it is installed in the product and packaged in a plastic bag. Remove the Back Panel (Pre- Place the filter within the Filter).
OPERATION POWER ON/OFF START STOP NOTE • Unless the power plug has been unplugged, the operation starts in the previous mode it was operated in. QUICK CLEAN By continuously discharging strong airfl ow cycles in 60 minutes, the product eff ectively removes airborne dust, pollen, mold and allergens from the air as they are drawn through the fi...
CARE AND MAINTENANCE Always be sure to remove the power plug from the wall outlet. • To maintain optimum performance of this air purifi er, please clean the product including the fi lter periodically. MAIN UNIT Wipe with a dry, soft cloth. For stubborn stains or dirt, use a soft cloth dampened with warm water.
Page 11
FILTER REPLACEMENT GUIDELINES Replacement timing When REPLACE FILTER Lamp turns on*. * The REPLACE FILTER Lamp will turn on after approximately 17,500 hours. (2 years × 24 hours = 17,500) Filter life varies depending on the operation mode. After the fi lter is replaced, connect the power plug to the wall outlet and press the Power ON/ OFF Button, then REPLACE FILTER Button for 3 seconds.
• Immediately after removing the plastic bag, a slight odour may occur. and/or fi lter. This odour is not harmful for fi lter performance or human exposure. SPECIFICATIONS Model UA-PE30U Power supply 220 – 240V ~ 50 – 60Hz Fan Speed Adjustment SLEEP Rated Power (W) Speed...
Page 13
Return is free of charge. If the equipment has been used for BUSINESS PURPOSES, please contact your SHARP dealer who will inform you about take-back. You might be charged for the costs arising from take-back. Small equipment (and small quantities) might be taken back by your local collection facility.