Table of Contents
Advertisement
Releasing the Electric
Brake
You can manually release the electric brake by
rotating the link arms forward. Once the electric brake
is energized, the brake resets.
1.
Turn the key to the
the battery.
2.
Loosen the bottom 2 bolts holding the
mower-deck curtain to the mower deck. Refer to
Releasing the Mower-Deck Curtain (page
3.
Locate the shaft on the electric brake where the
brake link arms are connected
4.
Rotate the shaft forward to release the brake.
5.
Tighten the bottom 2 bolts for the mower-deck
curtain to the mower deck. Refer to
the Mower-Deck Curtain (page
Figure 51
1. Brake-link arm on the electric brake control module
2. Left, rear tire
Adjusting the Tracking
When driving the machine forward full speed across
a flat, level surface, if the machine pulls to 1 side,
adjust the tracking.
If the machine pulls to the left, adjust the right
motion-control lever; if the machine pulls to the right,
adjust the left motion-control lever.
Note:
You can only adjust the tracking for driving
forward.
1.
Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
position or disconnect
OFF
(Figure
51).
Releasing
30).
ARK
3.
Locate the tracking-adjustment bolt near the
motion-control lever on the particular side that
needs adjusting
Note:
adjustment bolt.
4.
Rotate the bolt to decrease the speed for that
particular wheel.
Note:
minor adjustments.
30).
g294417
1. Bolt
5.
Start the machine and drive forward across a
flat, level surface with the motion-control levers
fully forward to check if the machine tracks
straight. Repeat the procedure as needed.
40
(Figure
52).
Raise the seat for easier access to the
Rotate the bolt a small amount to make
Figure 52
g294926
Advertisement
Table of Contents
