Table of Contents
Advertisement
Figure 65
1. Wood block—6.6 cm
(2-5/8 inches) thick
6.
Remove the hairpin cotter and washer from the
lower lift-arm pin
(Figure
Figure 66
1. Height-of-cut plate
2. Hairpin cotter
7.
Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
g294196
2. Wood block—7.3 cm
(2-7/8 inches) thick
66).
g294197
3. Washer
(Figure
67).
8.
Install the washer and hairpin cotter
9.
Repeat steps
the machine.
10.
Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11.
Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
46
Figure 67
(Figure
6
through
8
for the other side of
g294195
67).
Adjusting
47).
Advertisement
Table of Contents
