Table of Contents
Advertisement
Releasing the Electric Brake
The electric brake releases by manually rotating the link arms
forward. Once the electric brake is energized, the brake resets.
1. Turn the ignition key to the
the battery.
2. Locate the shaft on the electric brake where the
brake-link arms are connected
3. Rotate the shaft forward to release the brake.
Figure 43
1. Brake-link arm on the electric-brake-control module
2. Rear wheel
position or disconnect
OFF
(Figure
43).
Cooling System
Maintenance
Cleaning the Engine Screen
Service Interval: Before each use or daily—Clean the engine
air-intake screen.
To ensure proper cooling, ensure that the grass screen,
cooling fins, and other external surfaces of the engine are
kept clean at all times.
Use a dry brush to clean grass and accumulated debris from
the air-intake screen and around the engine.
Important: To prevent contaminating the fuel system,
do not use water to clean the engine.
Cleaning the Engine-Cooling
Fins and Shrouds
Service Interval: Every 100 hours—Clean the engine-cooling
fins and shrouds.
1. Disengage the blade-control switch, move the control
levers to the N
EUTRAL
parking brake.
2. Shut off the engine, remove the key from the ignition
switch, and wait for all moving parts to stop before
leaving the operating position.
3. Remove the air-intake screen and cooling shrouds.
4. Clean the debris and grass from the engine parts.
5. Install the air-intake screen and cooling shrouds.
35
-L
position, and apply the
OCK
Advertisement
Table of Contents
