Related Manuals for Flo Fab FF2BSE411
Summary of Contents for Flo Fab FF2BSE411
- Page 1 Installation, Operation & Maintenance Manual Submersible Non-Clog Sewage Pumps FF2BSE411 FF2BSE511 0.4 & 0.5 HP @ 1750 IMPORTANT! - Read all instructions in this manual before operating or servicing a pump.
-
Page 2: General Safety Information
IMPORTANT! - Flo Fab Pumps is not alarm that signals a malfunction of the swimming pools or water... - Page 3 NEMA L, single phase, permanent split capacitor, oil lled, with overload protection in motor. CORD CORD LOCKED WEIGHT MODEL PART No. VOLTS PHASE (Nominal) AMPS ROTOR AMPS SIZE TYPE (pounds) FF2BSE411 1750 22.5 14/3 SJTOW FF2BSE411A 1750 22.5 14/3 SJTOW FF2BSE421 1750 12.5 14/3 SJTOW...
-
Page 4: Recommendations And Warnings
Recommendations and Warnings Receiving inspection Liquid Level Control Upon receiving the pump, it should Typical Discharge Pipe Mounted: inspected damage Refer to Figure 2 below which shows shortages. If damage has occurred, a typical installation of a 1 phase 115 le a claim immediately with the volt pump using a level control company that delivered the pump. -
Page 5: Installation & Service
Installation & Service Both a check valve and a shut-o WARNING 5. Pump-Down Test - Be sure pump DO NOT ALLOW THE valve are recommended for each PUMP TO CYCLE OR RUN IF AN has been properly wired, lowered pump. The check valve is used to into the basin, sump or lift station, OVERLOAD CONDITION OCCURS. - Page 6 Service Disassembly If oil is found to be clean and Impeller, V-ring and Volute: uncontaminated (measuring 1. Disconnect power. above 15 kV breakdown), re ll the housing. If oil is found to be dirty or Remove capscrews contaminated (or measures below lockwashers, vertically lift motor 15 kV breakdown), the pump housing and seal plate assembly from...
- Page 7 Service 11. Inspect motor winding for shorts 3. Place seal’s retaining ring, spring 11. Clean the threads with thread and check resistance values. Check onto shaft. Lightly oil (Do not use locking compound cleaner. Apply rotor for wear. If rotor or the stator removable Loctite®...
-
Page 8: Repair Parts
Repair Parts For Repair Part Please supply: Model Number and Serial as shown on Name Plate, and Part Description and Part Number as shown on Parts List. -
Page 9: Parts List
Parts List ITEM DESCRIPTION QTY. MATERIAL CABLE ASSEMBLY (14AWG-3) PUMP BODY HT200 CAPACITOR 25µF/370V 90 °C ALUMINIUM CAPACITOR SET NBR40 UPPER BEARING PLATE ZL102 BEARING 6201 WAVE WASHER 65Mn TEMPERATURE PROTECTOR STATOR 10 ROTOR COMPONENT 11 STATOR COMPONENT STEEL 12 HEX. HEAD BOLT 5/16"-18UNC x 63 SS 304 13 SPRING WASHER SS 304... -
Page 10: Troubleshooting Chart
NOTE: Flo Fab Pumps assumes no responsibility for damage or injury due to disassembly in the field. Disassembly of the pumps or supplied accessories other than at Flo Fab Pumps or its authorized service centers, automatically voids warranty.