Related Manuals for Flo Fab 2FFSTEP
Summary of Contents for Flo Fab 2FFSTEP
- Page 1 Installation, Operation & Maintenance Manual Submersible E uent Pumps 2FFSTEP 0.5 & 1 HP @ 3450 RPM IMPORTANT! - Read all instructions in this manual before operating or servicing a pump.
-
Page 2: General Safety Information
IMPORTANT! - Flo Fab Pumps is not installations where there is responsible for losses, injury or human contact with pumped uid. -
Page 3: Optional Equipment
Additional cord, seal material, impeller trims, slide rail coupling (SRC-2). NEMA CORD CORD LOCKED WEIGHT MODEL PART No. HP VOLTS PHASE (Nominal) AMPS ROTOR AMPS CODE SIZE TYPE (pounds) 2FFSTEP 3450 13.1 26.2 14/3 2FFSTEP 512A 3450 13.1 26.2 14/3 3450 13.2 14/3 2FFSTEP 1022 3450 23.5... -
Page 4: Recommendations And Warnings
Recommendations and Warnings Receiving inspection Installation Liquid Level Controls Upon receiving the pump, it should There are two methods of installing Typical Discharge Pipe Mounted: inspected damage e uent pumps: Refer to Figure 2 below which shows shortages. If damage has occurred, 1. -
Page 5: Installation & Service
Installation & Service Overload Protection: 2. Check Pump Rotation - Improper 115V, 1Ph Single Phase - The stator in-winding motor rotation can result in poor overload protector used is referred to pump performance and can as an inherent overheating protector damage the motor and/or pump. - Page 6 Service Servicing Oil Replacement - Set unit upright Cooling Oil - Anytime the pump is and re ll with new cooling oil as per removed from operation, the cooling table below . Fill to just above motor, oil in the motor housing should be but below capacitor as an air space checked visually for oil level and must remain in the top of the housing...
- Page 7 Service To reassemble, clean the threads with Nothing should come in contact with If needle does not move or moves to thread locking compound cleaner. the seal face except the seal tool. Be in nity (∞) and does not drift back, Apply removable Loctite®...
-
Page 8: Repair Parts
Repair Parts FFBPSTEP For Repair Part Please supply: Model Number and Serial as shown on Name Plate, and Part Description and Part Number as shown on Parts List. -
Page 9: Parts List
Parts List FFBPSTEP ITEM DESCRIPTION MATERIAL Cable Assembly 20 ft O-ring Ø4.5" x 3.1" NBR40 Pump body HT200 Capacitor 25uf/370V 90 °C Aluminium Upper bearing plate ZL102 Bearing 6203 Wave washer 39 65Mn Temperature protector Stator 10 Rotor component 11 Stator component 12 Hex head bolt 5/16"... -
Page 10: Troubleshooting Chart
NOTE: Flo Fab Pumps assumes no responsibility for damage or injury due to disassembly in the eld. Disassembly of the pumps or supplied accessories other than at Flo Fab Pumps or its authorized service centers, automatically voids warranty.