Related Manuals for Flo Fab FFBPEV512
Summary of Contents for Flo Fab FFBPEV512
- Page 1 Installation, Operation & Maintenance Manual nt Pumps FFBPEV512 0.5 @ 3450 RPM IMPORTANT! - Read all instructions in this manual before operating or servicing a pump.
-
Page 2: General Safety Information
IMPORTANT! - Flo Fab Pumps is not installations where there is systems, that are required to reduce responsible for losses, injury or human contact with pumped uid. -
Page 3: Optional Equipment
Additional cord, slide rail coupling (SRC200). CORD CORD LOCKED WEIGHT MODEL PART No. HP VOLTS PHASE (Nominal) AMPS ROTOR AMPS SIZE TYPE (pounds) FFBPEV512 62180201 3450 16/3 SJTOW FFBPEV512A 62180202 3450 16/3 SJTOW A = Automatic Float Switch 2" NPT 6.45" 13.7" 3.23"... -
Page 4: Receiving And Installation
Receiving & Installation Receiving inspection Liquid Level Control Upon receiving the pump, it should Typical Discharge Pipe Mounted: inspected damage Refer to Figure 2 below which shows shortages. If damage has occurred, a typical installation of a 1 phase 115 le a claim immediately with the volt pump using a level control company that delivered the pump. -
Page 5: Installation & Service
Installation & Service Both a check valve and a shut-o This means that overload 3. Name Plate Record valve are recommended for each protector will trip out and shut the information from the pump name pump. The check valve is used to pump o if the windings become too plate to drawing in front of prevent back ow into the sump. - Page 6 Service With a ashlight, visually inspect the Apply pipe thread compound to 7. Remove screws and washers and oil in the housing to make sure it is threads of pipe plug then assemble lift motor housing and stator from clean and clear, light amber in color to housing.
- Page 7 Service Reassembly Motor: IMPORTANT! - All parts 5. Slide rotor/shaft with bearings and must clean before seal parts into seal plate until bearing reassembly. Handle seal seats into seal plate. Install snap ring parts with extreme care. DO NOT into seal plate. damage lapped surfaces.
-
Page 8: Repair Parts
Repair Parts FFBPEV512 For Repair Part Please supply: Model Number and Serial as shown on Name Plate, and Part Description and Part Number as shown on Parts List. -
Page 9: Parts List
Parts List FFBPEV512 ITEM DESCRIPTION QTY. MATERIAL Cable assembly 20 ft Pump body HT200 Capacitor 30uf/300V 90° C Plastic Pin Capacitance clip Cross recessed pan head screw M4x10 Q235A Ground lead Upper bearing plate ZL102 Temperature protector 17AM032-05 Stator 10 Rotor... -
Page 10: Troubleshooting Chart
NOTE: Flo Fab Pumps assumes no responsibility for damage or injury due to disassembly in the eld. Disassembly of the pumps or supplied accessories other than at Flo Fab Pumps or its authorized service centers, automatically voids warranty.