Table of Contents
Related Manuals for Flo Fab 8FFSEHA Series
Summary of Contents for Flo Fab 8FFSEHA Series
- Page 1 Installation, Operation & Maintenance Manual Submersible Non-Clog Sewage Pumps 8FFSEHA 30, 40, 50, 60, 75 @ 1150 RPM 100, 125, 200 @ 1750 RPM IMPORTANT! - Read all instructions in this manual before operating or servicing a pump.
-
Page 2: General Safety Information
IMPORTANT! - Flo Fab Pumps is not alarm that signals a malfunction of the swimming pools or water... - Page 3 Speci cations & Dimensions DISCHARGE: 8", 125lb, ange horizontal. SPHERICAL SLD HNDLG: 3" LIQUID TEMPERATURE: 104° F (40° C) max. VOLUTE: Cast iron ASTM A-48 class 30. WEAR RING: Bronze. MOTOR HOUSING: Cast iron ASTM A-48 class 30. SEAL PLATE: Cast iron ASTM A-48 class 30.
-
Page 4: Recommendations And Warnings
Recommendations and Warnings Receiving inspection Installation Liquid Level Controls Upon receiving the pump, it should These pumps are recommended for The level control(s) should be inspected damage use in a sump, basin or lift station. mounted on the discharge piping, a shortages. -
Page 5: Installation & Service
Installation & Service Overload Protection: If current through the temperature 3. Name Plate Record Three Phase - The Normally Closed sensor exceeds the values listed, an information from the pump name intermediate control circuit relay plate to drawing in front of manual (N/C) thermal sensor is embedded in must be used to reduce the current for future reference. - Page 6 Service THREE-PHASE 460V AC Clean out the pump body, if Install impeller and motor assembly necessary, examine wear ring (13) onto volute (12). Apply thread L2 L3 and replace if worn. If the wear ring locking compound to threads of each requires replacing, split the wear ring cap screw (2).
-
Page 7: Repair Parts
Repair Parts Figure 3 SHAFT KEY PART LIST ITEM PART No. DESCRIPTION QTY. RELIANCE MOTOR 91010015 LOCKWASHER 5/8" STAINLESS 8-16 91010355 CAP SCREW 5/8" x 2" STAINLESS MOTOR GASKET 03020022 ADAPTER 91010396 SOCKET HD SCREW 5/8" x 1½" STAINLESS 30400105 MOTOR ADAPTER 03140107 IMPELLER 30400415 IMPELLER WASHER 91010064 LOCKWASHER 3/4"... -
Page 8: Troubleshooting Chart
NOTE: Flo Fab Pumps assumes no responsibility for damage or injury due to disassembly in the field. Disassembly of the pumps or supplied accessories other than at Flo Fab Pumps or its authorized service centers, automatically voids warranty.