Table of Contents
Advertisement
Warning! Your product is designed for light spills only.
This appliance can also be used to pick up everyday liquid
u
spills. Use the squeegee accessory on non-absorbent,
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
For best performance on hard surface wet pickups, insert
u
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the appli-
u
ance at an angle of 45° and pull it slowly towards you.
Do not fill the bowl beyond the end of the intake chute. If
u
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
After picking up liquid substances clean the appliance and
u
filter immediately. Mold and mildew may form if the unit is
not properly cleaned after wet pickups.
Before charging, be sure to empty all liquid contents and
u
dry thoroughly, to avoid damage to your appliance.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (fig. F & G).
Warning! The filters are re-usable and should be cleaned
regularly.
Press the bowl release button (2) and pull the dust bowl
u
(3) straight off.
While holding the dust bowl over a bin or sink, pull out the
u
filter to empty the contents of the bowl.
To replace the dust bowl, place it back onto the handle
u
until it "clicks" firmly into position.
Warning! Never use the appliance without the filters. Opti-
mum dust collection will only be achieved with clean filters.
Foam insert (fig. H) (WDB units Only)
Place the foam insert (8) into the centre of the wet/dry
u
deflector (9).
Warning! Never use the appliance for wet applications without
the water deflector and foam insert fitted.
Pre-filter (fig. I) (NVB units Only)
The Filter and pre-filter can be separated to allow better
cleaning.
Twist the pre-filter (7) in an anti-clockwise direction and lift
u
from the filter (6).
Warning! Never pick up wet applications with these units.
(Original instructions)
Cleaning the dust bowls and filters
The dust bowls and filters can be washed in warm soapy
u
water.
Make sure that the filters and the dust bowl are dry before
u
re-fitting.
Replacing the filters
The filters should be replaced every 6 to 9 months and when-
ever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer:
For models: NVB115W, NVB115WA, NVB215W, NVB215WA
use filter part number FLVD10-XJ
For models: WDB115W, WDB115WA, WDB215W,
WDB215WA use filter part number FLWD10-XJ
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
ENGLISH
7
Advertisement
Table of Contents
