Table of Contents
Advertisement
1
A
C
B
3
Combination switch
2
The light switch has 3 switch positions.
A
= Light off
B
= Low beam light
C
= High beam light
The red short circuit button
switch pressed, until the engine stops. With the button
sound.
Flasher switch
The flasher switch is a separate unit and is mounted on the left portion of
the handlebar.
The wire harness is designed in a way that whenever you want to use your
bike off-road, you can dismount the entire turn indicator system without
affecting the function of the remaining electrical system.
Flasher left
Flasher right
Emergency OFF switch (Australia)
The emergency OFF switch
designed as safety or emergency OFF switch, it should normally not be in its
activated state.
In this position, the ignition circuit is shorted; if the engine is running,
it will stall immediately, if it is at standstill, it will not start.
In this position, the ignition circuit is enabled; the engine should start.
Filler cap
To open filler cap: Turn the filler cap counter-clockwise.
To close filler cap: Screw on the filler cap clockwise.
Install tank breather hose
4
Fuel tap
OFF In this position the fuel tap is closed. No fuel may flow to the carburetor.
ON When using the motorcycle, the rotating handle must be set to the
ON position. Now fuel may flow to carburetor. In this position the
tank empties down to the fuel reserve of approx. 2,5 liters.
RES The reserve tank, approximately 2,5 liters, cannot be tapped until the
rotating handle is turned to the RES position. Fill the tank as soon as
possible and remember to turn the rotating handle back to the ON
position so that you will have backup fuel next time, too.
1
serves to switch off the engine. Leave the
5
is located next to the throttle grip. Primarily
3
without kinks.
2
the horn will
11
Advertisement
Table of Contents
