Table of Contents
Advertisement
a
ease
Operating the Drive
This section describes how to operate the drive. It also describes how to eject the
drawer from the drive.
Starting the Drive
To start the drive, follow the procedure below:
1 Tum on the power supply.
2
Press the eject button. The drawer is ejected from the drive, Then, pull the
drawer softly.
3
Place the disc in the drawer with the disc's label facing up. Then, restore the
drawer softly until it is locked in the drive.
Note: CDU33A may not begin reading the Table of Contents (TOC) after disc
insertion. This is dependent on the host computer's software control. This
operation is similar to that of the floppy disk drive.
For an explanation of subsequent drive operations, follow the instructions provided
with the application software.
Ze Operating the Drive
Advertisement
Table of Contents
