Mitsubishi Electric VL-100U5-E Operating Instructions Manual page 8

Note
- Do not wash the filter as below, otherwise
it can be distorted.
- Do not wash the filter with hot water.
- Do not wash the filter by rubbing or
scrubbing.
- Do not squeeze or twist the filter.
Replacement:
The filter is a consumable part.
We recommend to replace the filter with the
replacement filter (P-100F5-E) after you have
washed the filter four times.
Cleaning the exhaust air filter
Use a vacuum cleaner to remove dust.
Note
- Do not press wires, screwdrivers or hard
vacuum cleaner nozzles into the surface
of the exhaust air filter. (Doing so may
damage the filter.)
Cleaning the Lossnay Core
Clean the Lossnay Core at least once a year.
Use a vacuum cleaner to remove surface dust.
- Vacuum the surface gently with the vacuum
cleaner nozzle.
Exhaust air
filter
Vacuum cleaner
Vacuum cleaner
Lossnay Core
Eng-7
Note
- Do not expose the Lossnay Core to water,
chemicals, or volatile solutions.
- Do not expose the Lossnay Core close to
open flames.
- Do not press wires, screwdrivers or hard
vacuum cleaner nozzles into the surface.
6. Reassembly and checking after
maintenance
Mount the filter and Lossnay Core by the
opposite of the removal procedure.
Caution
- After maintenance, reattach parts securely.
- Injury could result if the unit falls.
1. Mount the outside air filter. (See page 5.)
- Place the outside air filter into the filter
frame and mount it in the main unit. (Do not
confuse the top and bottom.)
2. Mount the Lossnay Core.
(1) Hang the center of the lower part of the
Lossnay Core onto the catch on the main unit.
Core
handle
Lossnay Core Main unit catch
(2) Press the top of the core handle into the
main unit until you hear a click.
Note
- Make sure that the center catches on the
top and bottom of the handle and the two
ends of the core are inserted all the way in.
Panel
Top of core
handle
Lossnay Core
Main unit
Main unit