the target, pull the trigger, and center the aiming beam on the symbol. If the code
being scanned is highly reflective (e.g., laminated), it may be necessary to tilt the
code up 15° to 18° to prevent unwanted reflection.
Menu Bar Code Security Settings
Honeywell scan engines are programmed by scanning menu bar codes or by send-
ing serial commands to the scan engine. If you want to restrict the ability to scan
menu codes, you can use the Menu Bar Code Security settings. Contact your Hon-
eywell OEM representative for more information.
Set Custom Defaults
You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the back cover, then a Save code, that entire sequence
will be saved to your custom defaults. When you have entered all the commands
you want to save for your custom defaults, scan the Save Custom Defaults bar
code.
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had previ-
ously saved the setting for Beeper Volume at Low to your custom defaults, and
decide you want the beeper volume set to High, just scan the Set Custom Defaults
bar code, then scan the Beeper Volume High menu code, and then Save Custom
Defaults. The rest of the custom defaults will remain, but the beeper volume set-
ting will be updated.
Reset the Custom Defaults
If you want the custom default settings restored to your scan engine, scan the Acti-
vate Custom Defaults bar code below. This is the recommended default bar code
for most users. It resets the scan engine to the custom default settings. If there are
N4680 2D Decoded Scan Engine User Guide
Set Custom Defaults
Save Custom Defaults
5