CHAPTER
2
PROGRAMMING THE INTERFACE
Introduction
This chapter describes how to program your system for the desired interface.
Programming the Interface
Use the following configuration bar codes to program the interface.
Note: After you scan one of the codes, power cycle the host terminal to have the interface in
effect.
RS232 Serial Port
The RS232 Interface bar code is used when connecting to the serial port of a PC or
terminal. The following RS232 Interface bar code also programs a carriage return
(CR) and a line feed (LF) suffix, baud rate, and data format as indicated below. It
also changes the trigger mode to manual.
Option
Baud Rate
Data Format
TERMID0;232BAD9;232WRD2
N4680 2D Decoded Scan Engine User Guide
Setting
115,200 bps
8 data bits, no parity bit, 1 stop bit
RS-232 Interface
7