Range Of Use; Technical Data; Scope Of Delivery - T.I.P. EXTREMA 400/11 CX Translation Of Original Operating Instructions

2. Range of use

Submersible dirty water pumps from T.I.P. are highly efficient electrical pumps for discharging clear or dirty water
containing solids up to the maximum size specified in the technical details. These high-quality products with their
convincing performance data were developed for the multiple purposes involved with draining and pumping
liquids from one place to another.
Typical applications for waste water submersible pumps are: Emptying ponds, tanks, storage tanks, and waste
water pits, as well as emergency drainage in the event of flood or high water.
Submersible dirty water pumps from T.I.P. are suitable for stationary or temporary installations.
This product is intended for private use in the home area and not for commercial or industrial purposes.
The device is not suitable for use in swimming pools or for installation in public water mains.
The pump is not suitable for use in table-top fountains, aquariums or similar ranges of use.
When using the unit in a pond, please take the required action to ensure that no inhabitants of the pond will be
sucked in.
The pump is not suited to discharge saltwater, feces, inflammable, etching, explosive or other
hazardous liquids. Please observe the max. temperature of the liquids to be discharged stated
in the technical data. The short-term operation (max. 4 min.) period with a liquid temperature
of up to 95°C is a special feature of this pump.
Inside the pump, lubricants are used which may contaminate the liquids being discharged in
case of any improper operation or damage of the device. The lubricants used are biologically
degradable and non-hazardous to health.

3. Technical Data

Model
Mains voltage / frequency
Nominal performance
Protection type
Pressure port
1)
Max. flow rate (Q )
max
Max. pressure
Max. delivery height (H )
max
Max. submersion depth 
Max. size of the solids being pumped
Max. fluid temperature normal use (T
Max. fluid temperature short termed (T
Max. cut-in frequency in one hour
Length of connection cable
Cable type
Weight (net)
Min. self-priming level (A)
2)
Min. suction level (B)
2)
Cut-in level (C)
2)
Cut-out level (D)
Dimensions (L x D x H)
Item no.
1)
The values were determined with free, unreduced outlet.
2)
The values between brackets refer to the illustrations given at the end of these operating instructions.
3)
When water temperature exceeds 50 °C, but not exceeds 95 °C, it only operates 4 min, then stop until the
motor completely cool down.

4. Scope of delivery

The scope of the delivery of this product includes:
One pump with connection cable, one operating manual, 3 reducer pieces (measurements refer to chapter 5.2).
Please verify that the scope of delivery is complete. Depending on the purpose of the application, additional
accessories may be necessary (please refer to the chapters titled "Installation" and "How to order spare parts").
1)
)
max
≤ 4 min)
3)
max
2)
EXTREMA 400/11 CX
230 V~ / 50 Hz
1,500 Watt
IPX8
57.29 mm (2"), female
24,000 l/h
1.1 bar
11 m
7 m
40 mm
50 °C
95 °C (max. 4 min.)
30, evenly distributed
10 m
H07RN-F
~ 13.8 kg
115 mm
55 mm
440 mm
130 mm
24.5 x 17 x 42.5 cm
30168
2
9