Midea MDWMINIPLUS User Manual page 23

Saving Energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption
and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is
used according to the instructions.
Starting A Program
Starting a wash cycle...
Draw out the basket(see the section entitled "Loading the basket").
Pour in the detergent (see the section"Adding detergent").
Insert the plug into the socket. The power supply is 220-240VAC 50 HZ, the specification
of the socket is 10 A 250 VAC.
Press the power button to turn on the appliance,
Connect the inlet hose to the tap, make sure that the water supply is turned on to full
pressure, or add water the the tank manually.
Select a suitable program according to the "Wash cycle table";
If a program is selected, the response light will light. Then press the Start/Pause button,
the dishwasher begins to start.
NOTE
When you press the Start/Pause button to pause during washing, the dishwasher will
mooing every minute unless you press the Start/Pause button to start.
Changing The Program Mid-cycle
Premise: You can modify the washing program, If the dishwasher just worked for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water in this case, the cycle must be restarted.
Press Start/Pause button to pause the machine when the door is closed.
Press any program button more than 3 seconds the machine will be in stand by state,
then you can change the program to the desired cycle setting
(see the section entitled " Starting a program" ).
The Display window shows the state of the dishwasher:
a) Display window shows "-:--" ----------------------------------> stand by;
b) Display window shows "H:MM" and not blinking -------------> pause;
c) Display window shows "H:MM" and blinking ------------------------> run;
d) Display window shows "END" ------------------------> end.
NOTE
If you open the door during washing, the machine will pause. When you close the
door and press the Start/Pause button, the machine will keep on working after
10 seconds.
If your model has broken remember function, the machine will go on to finish the
selected program after the power cut.
22