Philips Lumea SC1994 Manual page 10

10
English
- This device is not intended for use by persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of
the device by a person responsible for their safety.
- Please read and follow these instructions to optimize the use of the
device and prevent/ minimize the risk of injury, skin reactions and side
effects.
- If you experience skin irritation or skin redness after treatment, wait until
it disappears before applying any product to your skin. If you experience
skin irritation after applying a product to your skin, wash it off with water.
If you still get skin reactions, stop using the device and consult your
doctor.
- If you notice a skin tone change since the last treatment we advise you to
perform a skin test and to wait 24 hours before your next treatment.
- Do not treat the same skin area more than once during a session. This
may increase the risk of skin reactions.
- Tanning with natural or artificial sunlight might influence the sensitivity
and color of your skin. Perform a skin test to determine the appropriate
light intensity setting.
- For hygienic reasons, the device should only be used by one person.
- Misuse can lead to eye damage. Protect the eye from exposure. Never
use the device on, near, or around the eyes and eyebrows.
- Before you use Lumea, you should clean your skin and make sure it is
hair-free, entirely dry and free from oily substances.
- Do not use any pencil or pen to mark the areas to be treated. This may
cause burns on your skin.
- Children should be supervised to ensure that they do not play with the
device. Supervision is required to avoid potential risks such as exposure
to the light output, electrocution, strangulation from the cables or
choking on the attachments.
- Do not use the device if the UV filter of the light exit window and/or
attachment is broken, as safe operation cannot be guaranteed under
these circumstances.
- Do not use hair removal creams in the area (to be) treated with the
device, as chemicals may cause skin reactions.
- Always check the device before you use it. Make sure that the Skin tone
sensor window is clean when using the device, to avoid improper
operation. Please follow the instructions in Section 'Cleaning & Storage'
for cleaning the device.
- The adapter, light exit window and the filter of the attachments can
become very hot ( >210 °C/>410 °F ) during usage. Always let the adapter,
the light exit window as well as the filter and inner parts of the
attachments cool down before you touch them.
- The scattered light produced by the device is harmless to your eyes. Do
not look at the flash while using the device. It is not necessary to wear
goggles during use. Use the device in a well-lit room so that the light is
less glaring to your eyes.