Installing The Display Bezel - Dell Latitude 5520 Service Manual

CAUTION: Carefully pry and remove the display bezel to minimize the risk of display panel damages.
1. Using a plastic scribe, pry open the recesses near the left and right hinges on the bottom edge of the display bezel.
2. Carefully work your way around the edges of the display bezel to release it from the display back cover.
3. Lift the display bezel from the display assembly.

Installing the display bezel

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display bezel and provides a visual representation of the installation procedure.
Steps
NOTE: While installing the replacement display bezel for the models that are shipped with a camera, carefully peel off the
piece of tape that is used to secure the camera shutter to the replacement display bezel.
CAUTION: You must take extra care when peeling the tape. An abrupt peeling may remove the camera shutter
from the display bezel and damage the camera shutter.
1. Align and place the display bezel on the display assembly.
2. Gently snap the display bezel into place.
Next steps
1. Install the display assembly.
2. Install the base cover.
3. Install the microSD card.
4. Install the SIM card.
5. Follow the procedure in
76 Removing and installing components
After working inside your computer.