Table of Contents
Advertisement
No.
Item
• Clean.
• Inspect and adjust.
• Replace oil.
30 * Front fork leg(s)
• Replace oil seal.
• Clean and grease oil seals and
31
Protector guide
• Replace.
• Inspect and adjust.
• Grease pillow balls and bearings.
32 * Rear shock absorber
• Check for tightening torques.
• Adjust lever position and pedal
• Lubricate pivot point.
• Check brake disc surface.
• Check fluid level and leakage.
33 * Brake(s)
• Retighten brake disc bolts, caliper
• Replace pads.
• Replace brake fluid.
34 * Swingarm
• Inspect, lube and retighten.
Relay arm, connect-
• Inspect, lube and retighten.
35 *
ing rod
• Inspect free play and retighten.
36 * Steering head
• Clean and lube.
• Replace bearings.
• Inspect air pressure, wheel run-
• Retighten sprocket bolt.
37 * Tire, wheels
• Check the bearing.
• Replace bearings.
• Lubricate.
• Clean, lubricate, slack, alignment.
38 * Drive chain
• Replace.
39 * Drive chain guide
• Inspect wear.
• Replace.
Drive chain guide and
40 *
drive chain support
• Routing (Connection)
• Check and grease.
41
Cables
• Check throttle cables on the throt-
42
• Adjust clutch lever free play.
Levers
Routine
dust seals.
(After rain ride)
position.
bolts, master cylinder bolts and
union bolts.
(Check for tightening torques.)
(Check for tightening torques.)
(After rain ride)
out, tire wear and spoke loose-
ness.
tle body for dirt and wear.
MAINTENANCE INTERVALS
Every
After
race
third race
break-in
(about 2.5
(about 7.5
hours)
Every one year
3-3
Every
Every
fifth race
As
(about 12.5
required
hours)
hours)
Advertisement
Chapters
Table of Contents
Troubleshooting
