Advertisement
INSTALLATION
off valve in an easily accessible location.
Make sure all users know where and how
to shut off the gas supply to the range.
• Gas supply pressure for checking the
regulator setting is 6" WC.
Caution: The installer should inform
!
the consumer of the location of the
gas shut-off valve. Flexible Connector
Method.
1. Install male 1/2" flare adaptor at the
1/2" NPT internal thread of the range
inlet. Use a backup wrench on the elbow
fitting to avoid damage.
2. Install male 1/2" or 3/4" flare union
adapter on the NPT internal thread of
the manual shut-off valve.
3. Connect flexible metal appliance
connector.
4. Make sure circuit breaker is off and then
plug range cord in to electrical outlet.
5. Push range back into position insuring
that range leg slides under the anti-tip
bracket. The range will sit 3/4" away
from the wall when properly installed.
Warning: Be careful not to crimp flexible
!
connector!
6. Carefully tip range forward to insure
that anti-tip bracket engages and
prevents tip-over.
Rigid Pipe Method
• The configuration of the rigid pipe
connection will vary depending on the
location of the gas pipe stub. Refer to
Figure below for details.
1. Make sure circuit breaker is off and then
plug range cord in to electrical outlet.
2. Push range back into position insuring
that range leg slides under the anti-tip
bracket. The range will sit 3/4" away
from the wall when properly installed.
3. Carefully tip range forward to insure
that anti-tip bracket engages and
prevents tip- over.
4. Connect pipe to range at union. Access
the connection through the access
panel behind the warming drawer.
Proceed to Test for Gas Leaks.
Advertisement
