Honda CB450 1968 Service Manual page 111

100
Fig. 4. 88
CD
Balance mark
fig . 4. 89
CD
73.8 mm circl ip
®
® Rear wheel bearing retainer
®
® 34559 dust seal
®
© 6305 Z ball bearing
@)
® Rear wheel side collar
@
®
Rear wheel axle
@
4. FRAME
2. When the tire is replaced, the balance mark
of the tire (yellow) and the tube stem valve
must be matched (Fig. 4. 88). Rebalancing
must be performed.
4. 14 Rear Wheel
A. Construction
The rear wheel. consists of an aluminum costing
rear wheel hub which COfltains 6304 Z and 6305 Z
ball bearings, brake drum, and the brake panel.
A single cam rear brake panel is installed on the
right side through the panel collar . The hub and
final driven sprocket are mounted on the left side
of the wheel hub by the drive sprocket bolts.
(Fig. 4. 89)
@
Crass-section of rear wheel
Bearing retainer
@
Rea r axle nut
l O mm nut
@
Rear brake panel collar
l O mm tongue washer
@
Reor axle spacing co ll ar
Rear brake shoe
@
Driven sprocket bolt
6304 Z ball bear ing
@
Final driven sprocket
4.0 X 10 mm center pin
@)
Rear wheel hub