Honda CB450 1968 Service Manual page 110

4. 14 REAR WHEEL
99
NOl E:
Punch marks on the brake arm and broke cam
must be aligned.
(Fig. 4. 84}
4. Assemble the panel together with the distance
collar to the front wheel.
NOTE:
Speedometer coble end must be parallel to
the brake rod. (Fig. 4.
85)
5.
After tightening the front axle nut, mount the
front wheel on the fork, connect the front broke
stopper arm and assemble the front axle holder
with
8
mm nut.
6.
Connect the speedometer cab le to the gear
box.
7. Connect the front brake cable to the brake
arm and adjust the free travel. The specified
free travel is l 5~30 mm (0. 6~ 1.2 inl. Make
the adjustment with nuts "a" and "b" . (Fig.
4. 86)
8. Front wheel baioncing
( l l Raise the front wheel off the ground and
revolve the wheel slowly and allow the w heel
to stop naturally.
{2} Attach an appropriate weight on the spoke
nipple which is at the highest point. (4 different
weights are available) (Fig. 4. 87)
{31 R epeat this operation until the balance w eight
no longer stops in the same position.
{4}
When the balancing is completed, fasten
the weight securely.
NOTE:
l. After the wheel is balanced , do not move
or change weights.
fig . 4. 84 Insta ll ing the fro nt bra ke arm
CD
Front brake arm A
®
Front broke arm B
®
Front brake panel
Fig . 4. 85
CD
Front broke arm rod
®
Insta lli ng range
3
®
Speedmeter gear box
©
Front bro ke coble
Fig.
4. 86
Adj usting f ront brake leve r pl oy
WEIGHT
u
5g
!Og 15g
20g
Fig. 4 . 87 Balance weig ht