Transducer Specifications - JBL LSR6325P Owner's Manual

Sine Wave Power Rating: 50 watts (<0.1% THD into rated impedance)
Long Term Maximum System Power: 110 Watts (IEC 265-5)
Transducers:
Low Frequency Diameter: 134 mm (5.25 in.)
High Frequency Diameter: 25 mm (1 in.) diaphragm
Physical:
Enclosure Volume (net): 6.5 cu. liter (0.2 cu. ft.)
Cabinet Construction: Integrated with Die-Cast Aluminium
Dimensions (W x H x D): 17.3 x 26.9 x 24.1 cm
Notes:
All measurements unless otherwise stated made anechoically in a 4 environment at 2 meters and referenced to 1 meter by the
inverse square law.
The reference measurement microphone position is located perpendicular to the center line of the low and high frequency trans-
ducers, at the point 70 mm (2.7 in.) above the center of the woofer.
Acoustic loading provided by the listening room increases Maximum SPL capabilities and low frequency bass Extension as
compared to standard anechoic values.
Distortion measurements performed with the input voltage necessary to produce the stated "A" weighted SPL level at the stated
measurement distance. Distortion figures refer to the maximum distortion measured in any 1/10th octave wide band in the stated
frequency range.
JBL continually engages in research related to product improvement. New materials, production methods and design refinement
are introduced into existing products without notice as a routine expression of that philosophy. For this reason, any current JBL
product may differ in some respect from its published description, but will always equal or exceed the original design speci cations
unless otherwise stated.
THD+N, 1/2 power: <0.05%
High Frequency:
Topology: Class A-B, Monolithic
THD+1/2 power: <0.05%
Voice Coil: 38 mm (1.5 in.)
Magnet Type: Ferrite with Integral Shielding
Cone Type: Tempered Paper with Buty Rubber Surround
Nominal Impedance: 8 ohm
Voice Coil: 25 mm (1 in.)
Magnet Type: Ferrite with Integral Shielding
Diaphragm Type: Damped Titanium Composite
Other Features: Elliptical Oblate Spheroidal Waveguide
Nominal Impedance: 4 ohms
Finish: Smooth Dark Graphite
Grille: Black Steel Perforated
Low Frequency Vent: Dual Front Ported Linear Dynamics Aperture (Inte-
grated with die-cast baffle)
Baffle Construction: Integrated with Die-Cast Aluminium
Net Weight: 7.7 kg (17 lbs..)
(6.8 x 10.6 x 9.5 in.)
12