Page 1
PAW-BTANK50-100L 50-100 l. Languages in manual: EN - English HU - Hungary BK - Bulgarian - Italian CZ - Czech LV - Latvian DA - Danish NL - Dutch NO - Norwegian DE - German EE - Estonian PL - Polish ES - Spanish PT - Portugese - Finnish...
1. SAFETY INSTRUCTIONS 1.1 General information • Read the following safety instructions carefully before installing, maintaining or adjusting the buffer tank. • Personal injury or material damage may result if the product is not installed or used in the intended manner. •...
1.2 Safety instructions for users WARNINGS The appliance may be used by children older than 8 years old, elderly persons and persons with physical, sensory or mental disabilities or lacking experience and knowledge, if they are under supervision or taught about safe use of the appliance and if they are aware of the potential dangers.
Thermostat Volume Heat-up time Heat Product Product code: persons vol. m³ Dt 65°C loss W setting °C 40°C 80341985 PAW-BTANK50L-2 ø430x636 0,18 80341986 PAW-BTANK100L ø430x1175 0,27 2.5 ErP data - Technical Data Sheet Thermostat Heat Actual Brand Model-no. Model name...
Pcs. Description Buffer tank with sensor bracket Manual (this document) Automatic air vent (included) Drain cock (included) Wall bracket (incl. only for PAW-BTANK50L-2) 1” brass plug with o-ring seal (included) 3.2.1 Spare parts list Ref no. Part No. Description 765063 1/2” M Automatic air vent 514178 1/4”...
3.4 Requirements for installation location and positioning CAUTION The product shall be placed in a room with a drain to prevent any damages in case of water escaping from the product.. The product shall be placed in a dry and permanently frost-free position. The product shall be placed on a floor or wall suitable for the total weight of the product when in operation.
3.5 Pipe installation The product is designed to be permanently con- nected to the heating system, max. pressure 3 bar / 0,3 MPa. Approved pipes of the correct size should be used for installation. The relevant standards and regulations must be followed. Dimension Connection description 1/2”...
4. INITIAL COMMISSIONING 4.1 Filling with water First check that all pipes are connected correctly. Then do the following: A) Vent the system, preferably at its highest point. B) Open water supply to the product. When water flows out of the vent the system is full. C) Fit the Automatic air vent valve (1) to the top connection, max.
5. WARRANTY CONDITIONS WARRANTY 1. Scope lowing: The Distributor warrants for 2 years from the • Chloride < 250 mg / L date of purchase, that the Product will: i) con- • Total Dissolved Solids (TDS) < 500 mg / L form to specification, ii) be free from defects in •...
6. DISPOSING OF THE PRODUCT Information for users on collection and dis- posal of old equipment: 6.1 Disposal The shown symbols on the products, packag- ing and/or accompanying documents mean that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please bring them to applicable col- lection points in accordance with your national...
Need help?
Do you have a question about the PAW-BTANK50L and is the answer not in the manual?
Questions and answers