Table of Contents
Advertisement
Connect Add-on Sensors to Station
The wind station will accommodate up to two additional
•
thermo-hygro sensors (TX141TH-BCH, sold separately) on
channels 2 and 3.
Purchase at:
www.lacrossetechnology.com/tx141th-bch-temperature-humidity-sensor
Note: The TX141W sensor will use channel 1. No additional TX141W
wind speed sensors can be added.
Connect add-on sensor(s) to the wind station:
1. Remove the battery cover from all add-on sensors (leave off ).
2. Set the first additional sensor to Channel 2 and insert
2 "AA" batteries.
3. Set the second additional sensor to Channel 3 and insert
2 ""AA"" batteries.
4. Hold the DOWN ARROW button on the station for 5 seconds to
search for sensors.
5. Press the TX button on each sensor.
6. When connection is established, the temperature and humidity for
each of the selected channels will appear.
7. Install the battery covers on each sensor.
8. Keep sensors and the wind station 5-10 feet apart for 15 minutes
for a solid connection.
9. After 15 minutes, place the remote sensors in an appropriate
shaded locations.
10. Press and release the DOWN ARROW button to view channels 1, 2
or 3 on the wind station.
Note: If only one sensor is connected, the other channels will show
dashes for temperature and humidity.
View Channels (when add on sensors in use)
• Press the DOWN ARROW button to toggle between remote sensor
channels when multiple sensors are used.
• Channels are indicated with CH 1, CH 2 or CH 3, in the outdoor
temperature area.
327-1414Wv2
www.lacrossetechnology.com/support/
Page | 10
Hide quick links:
Advertisement
Table of Contents
