Table of Contents
Advertisement
LED Pointer Position ("W+" foot)
Standard： There is a needle drop point on the inside of pointer beam.
1. Attach the embroidery presser foot with LED pointer.
2. Go to the test mode #37.
3. Press
to adjust the pointer beam position.
Match the center of pointer beam with the front edge (#1) of needle
hole of needle plate.
4.
Check that there is a pointer beam in the range of 1.4 to 2.9mm from
the edge (#2) of the feed dog hole of needle plate.
5. Press "CLOSE".
#1
1.4mm
2.9mm
#2
65
Advertisement
Table of Contents
