Panasonic SV-3800 Operating Instructions Manual page 16

Playback Functions provided by the Remote Control Transmitter
To interrupt program play:
Press the STOP button.
To recall the programmed selections:
When the RECALL button is pressed once the STOP button has been pressed, the programming is restored.
After recalling the programmed selections by pressing the RECALL button, the additional programs can be
entered.
If the program number button is pressed instead of the RECALL button once the STOP button has been pressed,
the input program is cleared and programming commences anew from program 1.
Reference: The program is considered to be at its end in the following circumstances:
© When the Start ID of the next program has been detected
¢ When the Skip ID has been detected while the auto skip play mode is on
¢ When a blank section (in which an audio level of less than selected detection level continues for more than
2 seconds) has been detected while the program playback blank skip mode is on
(Refer to the system display functions and Automatic recording of program numbers.)
¢ When the tape has reached its end
Playing Tape Repeatedly (Repeat Play)
This function will repeatedly play either an entire tape, or programmed selections up to a maximum of 16 times.
1 Press the REPEAT button on the remote control transmitter. The repeat indicator illuminates.
2 Press the PLAY button. The play indicator illuminates, and play begins.
If all the segments are to be played repeatedly and an End mark is detected, the tape will return to the beginning
and playback will begin again.
To cancel repeat play:
Press the REPEAT button. The repeat indicator turns off and the unit returns to the original playback mode.
If the STOP button is pressed, repeat play is cancelled and the tape stops.
Setting the PNO/START ID AUTO detection level
The level at which a program is to be judged to have no sound can be set to any level in 10 dB increments between
-20 dB and -60 dB.
When the PNO/START ID AUTO button is pressed with the "auto" mode ON, the mode will be turned off.
When the same button is pressed with the "auto" mode OFF, the selected detected detection level is indicated
momentarily (for approx. 1.2 sec.). If the button is pressed again while the detection level is indicated, the level
is changed by one setting (40dB — —-50dB — -60dB — —-20dB — -30dB — —40dB, etc.).
E-16