Functional Description - Makita JN3201 Instruction Manual

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Permissible cutting thickness
1
2
► 1. Stainless steel gauge 2.5 mm (3/32") 2. Mild steel
gauge 3.2 mm (1/8")
The thickness of material to be cut depends upon the
tensile strength of the material itself. The groove on
the die holder acts as a thickness gauge for allowable
cutting thickness. Do not attempt to cut any material
which will not fit into this groove.
Max.cutting capacities
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
mm ga
3.2 10
2
2.5 13
2
1.0 20
2
3.5 10
2
Switch action
1
► 1. Switch trigger 2. Lock button
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
• Switch can be locked in "ON" position for ease of operator
comfort during extended use. Apply caution when locking
tool in "ON" position and maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Punch replacement
2
► 1. Wrench 2. Lock nut 3. Die holder
Fit the wrench provided onto the lock nut and tap the
handle lightly with a hammer to loosen the lock nut.
Take off the die holder and use a wrench to remove the
screw. Then remove the punch.
4 ENGLISH
2
1
3