For Your Safety - Panasonic PAW-SERVER-PKEA-1 Installation Instructions Manual

Read the following instructions carefully, and carry out secure installation and electrical work.
The precautions given in this manual consist of specific "Warnings" and "Cautions". They provide
important safety-related information. Be sure to strictly observe all safety procedures. The labels and
their meanings are as described below.
This symbol refers to a hazard or unsafe procedure or practice that can result in severe personal
Warning
injury or death.
This symbol refers to a hazard or unsafe procedure or practice that can result in personal injury
Caution
or product or property damage.
After installation is completed, perform a test run to check for operating trouble. Explain operating
procedures to the customer following the CONNECTION SCHEME and the OPERATION LOGIC.
 Be sure to arrange installation by the dealer where the system was purchased or by a professional installer. Electric
shock or fire may result if an inexperienced person performs any installation or wiring procedures incorrectly.
 Be sure that this unit is securely installed in accordance with these "Instructions for the Electrical Installer". Electric
shock or fire may result if any installation or wiring procedures are incorrectly performed.
 Only a qualified electrician should attempt to connect this system, in accordance with the instructions in this manual.
Insufficient electrical circuit capacity or incorrect installation may cause electric shock and fire.
 Use the specified cables for the electrical connections, and connect the cables securely. Run and fasten the cables
securely so that external forces or pressure placed on the cables will not be transmitted to the connection terminals.
Overheating or fire may result if connections or attachments are not secure.
 Depending on the installation conditions and location, an earth leakage breaker may be required. If an earth leakage
breaker is not installed, there is a danger of electric shock or fire.
 The installation location requires the use of a circuit breaker. Failure to use a circuit breaker may result in electric shock
or fire.
 Circuit breaker must be incorporated in the fixed wiring in accordance with the wiring regulations. The circuit breaker
must be an approved 10-16 A, having a contact separation in all poles.
 Ground yourself to discharge static electricity before performing any wiring.
PAW-SERVER-PKEA-1
Server Back-Up PC Board

For your safety

Warning
Caution
3
EN