Panasonic PAW-SERVER-PKEA-1 Installation Instructions Manual page 9

Only ON/OFF state will be possible through the dry contacts I1, I2 (you can find them on the
lower part of the PAW-SERVER-PKEA-1).
Third party BMS can just operate through dry contacts and there is no way to read or modify
the system parameters set by the Remote Controller.
It is also possibile to enable Dip-Switch n. 2 for "Energy Saving Mode"
Dip-Switch n. 4 ON: enables "Third Party BMS Management: mode "B" (remote controller

ENABLED)".
SETTING PROCEDURE
3. Switch ON the unit and set up operation parameters (mode, set temperature, fan speed,
vane position)
4. Set to ON Dip Switch n. 4
From now on ON/OFF state will be possible through the dry contacts I1, I2 (you can find them
on the lower part of the PAW-SERVER-PKEA-1).
Remote controller can operate normally.
Improper setting to ON of both Dip Switch n. 3 and 4, will be handled as Dip Switch n. 3 ON.
Third party BMS can just operate through dry contacts and there is no way to read or modify
the system parameters set by the Remote Controller.
It is also possibile to enable Dip-Switch n. 2 for "Energy Saving Mode"
Note: Service functions (RC Reset, AC Reset, Check) are not available through
For Service Functions connect the remote controller directly to the indoor unit.
Emergency button on the indoor unit is overridden by Remote Controller settings.
9
EN
PAW-SERVER-PKEA-1