Front Panel Facilities - Pioneer VSX-D6025 Operating Instructions Manual

FRONT PANEL FACILITIES
* Illustration shows model VSX-D702S.
QO @®
@ POWER STANDBY/ON switch/STANDBY indicator
This is the switch for electric power.
ON: When set to the ON position, power is supplied and the
unit becomes operational.
STANDBY: When set to STANDBY position, the main power flow is
cut and the unit is no longer fully operational. A minute
flow of power feeds the unit to maintain operation
readiness.
The STANDBY indicator lights when the power is
STANDBY, and goes out during ON.
[Timer ON/OFF possible]
When the unit is switched ON, ON/OFF control can be performed by
means of the optional timer.
NOTE:
When the power is initially tumed ON, muting will be applied to prevent
sound from being output for about 5 seconds.
@V-SIGNAL (VIDEO SIGNAL) SELECTOR button
Use to change the video signal in sequence leaving the sound
unchanged.
aes 4— VCR 2—+ LD— TV—+ VIDEO — OFF sae
The current setting is shown by an indicator on the display section.
18
<ARB1421>
®@®@OOODHO® ®
©®H ®80©60©0O0 ®
@ [t @ @
@) Remote sensor
@ AUTO SOURCE CONTROL/MEMORY buttons
(See page 29)
1, 2 buttons:
These buttons are for memorizing and recalling your current settings.
Both 1 and 2 can be used to memorize settings. If you connect another
component, such as a CD player, to the CONTROL OUT jack on the
rear panel, the signals to switch power on and start play are also
transmitted.
MEMORY:
Use when memorizing settings to a 1, 2 button.
©) MEMORY button (See page 23)
Pressing this button will result in the memorization of the current
broadcast band, reception frequency, and MPX AUTO/MONO mode.
This button is also used for custom memory operation.
© CUSTOM MEMO SEL button (See page 23)
Recall a genre name with this button.