Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ryobi R18CG
Summary of Contents for Ryobi R18CG
- Page 1 R18CG CORDLESS CAULKING GUN ORIGINAL INSTRUCTIONS...
- Page 2 DESCRIPTION 1. Caulk gun 7. Variable speed selector 2. Plunger rod 8. Plunger rod handle 3. Puncture tool 9. Battery pack (not included) 4. Carriage frame 10. Latches 5. Switch trigger 11. Spout 6. Switch lock 12. Caulk tube (not included)
- Page 4 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
-
Page 5: General Power Tool Safety Warnings
English GENERAL POWER TOOL SAFETY WARNINGS use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol WARNING or medication. A moment of inattention while Read all safety warnings and all instructions. operating power tools may result in serious Failure to follow the warnings and instructions personal injury. -
Page 6: Special Safety Rules
English e. Maintain power tools. Check for misalignment SPECIAL SAFETY RULES or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. If damaged, have the WARNING power tool repaired before use. Many accidents The product is not intended for use by persons are caused by poorly maintained power tools. -
Page 7: Operation
■ Applying adhesive. ■ LOCKING THE SWITCH TRIGGER This product will accept Ryobi One+ 18 V lithium-ion See Figure 3. battery packs and Ryobi One+ 18 V nickel-cadmium The switch trigger of the caulk gun can be locked off battery packs. -
Page 8: Maintenance
English any hardened material from the tip. attempt to remove the excess. NOTE: An inner seal is usually found only in Carefully move the caulk gun at an even pace along ■ cardboard caulk tubes. the gap to be filled as you continue to depress the While holding the caulk gun steadily with one hand, switch trigger. -
Page 9: Environmental Protection
English To work properly, the plunger rod of the tool must remain clean and free of all caulk and adhesive material. If material does get on the plunger rod mechanism, clean the material off according to the directions of the caulk or adhesive manufacturer. - Page 10 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 961152066-02...