Advertisement
ES
Po ae,
aR
A
A
a
E
PPL EE
ST T l
1
Plug in AC Adaptor.
POWER Lamp lights.
CHARGE
1
2
Lamp
Insert Battery.
G Align right side of Battery with line
on AC Adaptor.
© Press Battery down and slide in
direction of arrow.
CHARGE
Lamp lights and then goes
out when charging is done (approx. 1
and 1/2 hours).
3
Remove Battery
Slide Battery out and off.
* Battery life gradually decreases after
Note:
-
repeated use and recharging. If operation
After recharging 5 times, use BATTERY
time becomes very short even after a
REFRESH feature as explained on
sufficient charge, discard Battery properly
page 11.
(page 11).
A
-Using:the-Battery:
Rac
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
1
Attach Battery
G Align Battery with top of mounting
surface.
@ Press and snap into place.
BATTERY
PACK
2
Remove Battery
While sliding BATTERY RELEASE,
remove Battery.
10
For assistance, call 1-800-211-PANA(7262)
Advertisement
