Rollei 20160 Manual page 61

Photos do not capture subject?
• Check the "PIR SENSITIVITY" parameter setting (SETUP menu). For warm
temperature conditions, set this to "HIGH" and for cold weather use, set the PIR
sensitivity to "LOW". For variable weather, use "MEDIUM".
• Try to set your camera up in an area where there is not a heat source in the
camera's line of sight.
• In some cases, setting the camera near water will make the camera take images
with no subject in them. Try aiming the camera over ground.
• Try to avoid setting the camera up on small trees that are prone to being moved
by strong winds.
• Remove any limbs which are right in front of the camera lens.
PIR sensor led flashes/doesn't flash?
• When the camera is in the "Setup" mode, a special LED on the front of the
camera will flash when it senses motion. This is for setup purposes only and will
help the user aim the camera.
• During use, the LED will not visibly flash when the camera takes an image. The
LED array uses infrared light to help keep the camera hidden from game.
Display screen comes on but then powers off?
• The display automatically turns
to conserve battery power.
Solar panel won't charge?
• Please clean the surface of the solar panel to ensure it won't covered by dust.
• The solar panel charging temperature is between O degree to 50 degree, the
sunlight intensity, Irradiation time and ambient temperature all affect the charging
efficiency. Please ensure the camera is on the condition of sunshine.
if no control keys are pressed for 30 seconds,
off
61