Rollei 20160 Manual page 59

• Press the "R" reset button at the bottom of the camera to restart the camera
system in the condition of SO card and battery are installed correctly.
Camera takes continuous images of no subject?
A camera has what is known as a "false trigger" if the PIR sensor thinks that there is
motion and heat in front of the camera lens when there is no subject in the image.
These "False Triggers" are the result of placing the camera in an environment where
there is motion associated with tree branches creating motion in front of the camera
or an area where there is high heat in the foreground and any motion from wind
could sei off the camera. Setting a camera up over water is also a potential cause
for this issue. To remedy this situation:
• Try moving the camera to an area that does not have any of these issues or try
changing the sensor level on the menu settings.
• II the camera continues to take images when there is no subject in them, try
placing the camera in an inside environment and aiming at a location where
there is no motion.
• II the camera continues to show issues, then there is probably an electronic
component issue. II this is the case, please contact our customer service to
send the camera back for repair.
Battery life is shorter than expected?
• The setting you select for "PIR interval" and "Video Length" in the Setup Menu
will have a significant impact on battery life. Shorter interval time and long video
length setting are all lead to short battery life. We suggest to go with the
defaulted setting of lnterval time 30SEC or above, and the video length within
10sec.
• Battery life will vary with operating temperature and the number of images taken
over time. Typically, the Camera will be able to capture several hundred images
before the batteries die.
• Make sure that you are using a good quality name brand SO card in your
camera. We recommend SanOisk brand SO Cards up to 32GB. Our experience
indicates that poor quality SO cards can sometimes reduce your camera
battery life.
59