Setting Up The Live Mode - Rollei 20160 Manual

In this way you can determine the best position for aligning the camera. The
LED only lights up in the SETUP mode as soon as one of the sensors has
detected movement. The LEDs do not light up when in Live mode.
In order to prevent incorrect signals and unnecessary photos, we recommend
not using the camera at sunny points and check that no branches are in the
active area of the sensor. Optimum alignment is in North or South direction.
The detection range of the sensors is approx 60
Also check that the camera is sei to the correct height in line with the point to
be observed. Where necessary, point the camera down for optimum
alignment.
@('Note:
• Wildlife Camera corresponds to protection class IP 54. The camera is
protected against dust and spray water and can thus be used in any
weather condition.

6.4. Setting up the Live mode

The standard application of the Wildlife Camera
is the Live mode. When in this mode, photos are
either triggered by movement sensors or at
intervals according to the respective setting.
To sei up the Live mode, switch mode switch to
ON position.
The red status LED flashes for approx. 5 seconds alter which the camera
operates automatically and enters the Standby mode.
As soon as wild animals or other objects directly enter the detection area of
the central sensor zone, the camera starts to record photos and videos.
.
°
OFF SETUP ON
54
Lc:1g_J