Internal Wiring - Savant Power Storage 20 Installation Manual

3.3. Internal Wiring

1. Unfasten the screws from the battery storage wiring cover and wiring panel of the
Savant Power Inverter using a 4mm hex screwdriver, removing both cover plates.
2. Connect the inverter to the battery system with ground wire, Torque: 26.5 lb-in (3
N*m) feeding the ground wire through the BAT/COM to the battery storage wiring
panel.
3. Connect power, 12V DC and communication cables from the battery system to the
inverter. Insert the wires according to the corresponding colors of the silkscreen on
the terminal.
NOTE: Conductor colors of the 60A unit will differ from the installation guide.
2
Savant Power Storage 20 Installation Guide
009-2401-00 | 090623
PV1+ PV1- PV2+ PV2-
T R G
RS232
L H G
CAN
GPS
USB4
RESET
USB2 USB3 SD SIM
NETWORK
BAT/COM TO
BATTERY STORAGE
WIRING
1
REF BAT- BAT+
G B A
DC 12V DC 12V UPCS
P S G
RSD C-LED DC 12V
RS232
BCMS
C-LED RS485-1 DC 12V
DC 12V
- 12 -
REF DC- DC+ L1 N L2 L1 N L2 L1 N L2
GROUND
BAT/COM TO
INVERTER WIRING
REF BAT- BAT+
Copyright 2023 Savant Systems, Inc