Operating A Cable Box Or Dbs Receiver - Sony Trinitron KV-27S20 Operating Instructions Manual

Operating a cable
box or DBS receiver
You can program the supplied remote commander to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number in the remote commander.
—
DBS/CABLE (POWER)
DBS/CABLE
(FUNCTION)
DISPLAY*
0-9 buttons
JUMP
TV/DBS*
ENTER
GUIDE*
4/4/e/9/2)*
MENU*
CH +/-
CODE SET
—----- FUNCTION ——-
DBS/CABLE
FUNCTION
ENTER
CODE SET —_DBS'CABLE
SBR RES
POWER
DBS/CABLE
4 Use the cable box/DBS control buttons to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+/-,0-9 and ENTER buttons.
Note
e If the cable box or DBS receiver does not have a certain
function, the corresponding button on this remote commander
will not operate.
To operate the TV
Press TV (FUNCTION). Then use the TV control
buttons to control the TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.
If the remote commander doesn't work
¢ First, try repeating the setup procedures using the other codes
listed for your equipment.
Manufacturer code numbers (cable box)
Manufacturer Code number
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201, 202, 203, 204, 205, 206, 207, 208,
218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
Manufacturer code numbers (DBS receiver)
Manufacturer Code number
Sony 801 (preset code for the supplied
remote commander)
RCA 802
Notes
¢ If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
e If you enter a new code number, the code number you
previously entered at that setting is erased.
e Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.
Operations | 29